You can build sturdy, big planters using cinder blocks. Garden planter walls in up to 4 feet tall can be constructed using cinder blocks. Compared to a ground-level garden, there is less bend down needed to access a garden with soil hold back by the blocks cemented together. The total of cinder blocks required will be reduced by using the wall of the house as the back of the planter if you want your cinder block eclectic outdoor pots and planters is located close to your house. The planter will be able to have vertical walls formed from a straight surface of the house wall.
Locating The Planter
Use a house wall as one side of a square or rectangle planter shaping by arranging the planter's first row of cinder blocks. With the end of one block sitting aligned with the side of another block at each corner, place the blocks at the corners of square or rectangle. To account for mortar between the other blocks, provide a 1/4-inch space. Confirm the square corners with a right angle, and make sure there is a 90-degree angle formed by the corners of cinder block eclectic outdoor pots and planters. Use spray paint to mark the ground the length of the on the outside and inside edges of the cinder blocks. Take out the blocks from the marked area.
Between the marked lines, plow a ditch with the trench's depth the same to the height of a cinder block in addition 4 inches. Put in gravel in a 4-inch-deep layer into the trench. Use a tamping tool to fill the gravel. Read the mortar mix's package instructions when mixing a lot of mortar mix in a huge bucket. Apply down the first row of cinder blocks of the planter sides in 1/2 inch of mortar as the same way you put them in the ditch beforehand. Allow some of the mortar between blocks freeze out the sides as you thrust them together faintly, but between the blocks should have 1/4 inch of mortar.
Place the next line of cinder blocks over the earliest row of blocks, while you are applying mortar over the first-line blocks and placing second-row blocks over the joints amid first-line blocks of cinder block eclectic outdoor pots and planters. Bricks are laid similarly with this pattern.
Vary the arrangement of the blocks at the angle so the blocks adjoin against each other in a manner contrary to the way they adjoin in the earlier line. You may add a third line of cinder blocks by recur the practice.
Give the top of the planter wall some pavers or decorative capstones. Spread the top row of cinder blocks with mortar to lock the capstones. While the mortar is still wet, thrust a hole in the mortar every 4 feet down the planter 6 inches over the ground. Insert through each hole a plastic 1/4-inch-width drainage pipe. Add 2 inches to the breadth of the cinder block to decide the length of the pipes. Place peat moss and perlite above the tilled soil. Line up plastic sheeting along inside walls of planters and the house. Now you can use your cinder block eclectic outdoor pots and planters.